AlexP says:

The ‘cleye.config’ only applies to the DirectShow component of the driver.
If you are using the SDK and the CL-Eye Multicam API, this config file will have no effect.
When you say that the camera stops running at 60fps are you talking about VGA resolution?
In the processing example, try disabling any kind of camera parameter change during the capture. Depending on your machine speed you should be able to run at 60fps.

—Since I am a total newbie here, I have couple of questions regarding your instructions.
1)At this moment I have an i7 .(JavaScript must be enabled to view this email address), Win7-64bit. The CL-Eye-test works fine for the 30fps capture rate.
During the installation of your program, I have installed the SDK also.
Would this pose any problem with the effect of the config file, hindering the 60fps selection? Do I have to remove the SDK program?

2) How do I save your xml configuration file to my folder? Do I simply copy the contents and save as unicode text file and rename it afterwards?

Any suggestions are welcome,

Bryan